User Manual Q&AAnswer
May 03, 2025 - 05:20 AM
To program the DMP 1132 Wireless Recessed Door Contact, follow these steps:
1. Access the Programmer Menu on your panel by entering 6653 (PROG) at a keypad.
2. Enter the wireless zone number at the ZONE INFORMATION prompt.
3. Enter the zone name at the *UNUSED* prompt.
4. Select the zone type at the ZONE TYPE prompt by pressing any select key or area.
5. Enter the area number at the AREA NO prompt.
6. Select NO at the NEXT ZN? prompt.
7. When WIRELESS? is displayed, select YES.
8. Enter the eight-digit device serial number at the SERIAL# prompt.
9. Enter a supervision time at the SUPRVSN TIME prompt (default is 240).
10. Select YES at the NEXT ZN? prompt if you are finished programming the zone or NO to access additional programming options.
11. To save panel programming, go to STOP and press CMD.
For more detailed instructions, refer to the panel programming guide provided by DMP.
Note: The programming steps may vary depending on the specific panel model you are using.
Add New Comment