User Manual Q&AAnswer
May 03, 2025 - 04:40 AM
To install the Uolfin 5069602 2-Light Matte Gold Contemporary Vanity Light, please follow the instructions below:
1. Before starting the installation, ensure that the power is turned off. Go to the main fuse or circuit breaker box in your home and place the main power switch in the "OFF" position. Also, turn off the wall switch.
2. Make sure the mounting surface is clean, dry, flat, and strong enough to support the lamp. It should be 1/4" larger than the canopy on all sides. Correct any gaps exceeding 3/16" as required.
3. Check that the ceiling or wall can withstand the weight of the lamp before installation.
4. Ensure that the voltage you are using is 120V, and the maximum wattage for each bulb is 60W.
5. Keep the lamp away from acidic and alkaline substances to avoid damaging the surface.
6. When replacing bulbs, turn off or unplug the lamp and wait until it is cool, as bulbs can get hot quickly.
7. The safety instructions provided in the manual are not exhaustive. Always use common sense, caution, and care when working with electrical products.
Tools Required (Not Included):
- Screwdriver
- Wire connectors
- Electrical tape
Parts Included:
- Mounting plate
- Green ground xxxx
- Back plate
- Studs
- Arms
- Sockets
- Lids
- Glass shades
- Socket rings
Assembly & Installation Instructions:
1. Carefully remove the fixture from the packaging and ensure that all parts and accessories are included.
2. Turn off the power before starting the installation.
3. Unscrew the studs from the back plate and set them aside for later installation.
4. Pass the supply wires from the outlet box through the mounting plate. Secure the mounting plate to the outlet box using the provided mounting screws.
5. Make wire connections according to the provided chart. Twist the wires together with plastic wire connectors until tightly joined, and wrap each connector with approved electrical tape. Ensure no wire strands are exposed and carefully tuck all wires into the outlet box.
6. Align the holes in the back plate and mounting plate, then secure them with the previously removed studs.
7. Remove the lids and socket rings from the sockets.
8. Place the lids and glass shades on the sockets, then secure them with the socket rings.
9. Install bulbs (not included) according to the maximum wattage recommended on the socket.
10. Double-check that everything is installed properly before turning on the light.
Cleaning:
To clean the fixture, wipe it with a soft cloth. Clean the glass with a mild cleaner, such as mild and non-abrasive soap. Avoid using abrasive materials like scouring pads, powders, steel wool, or abrasive paper.
Ordering Parts:
If you need to order replacement parts, keep the provided sheet for reference. You can order all parts for this fixture from the place of purchase. Ensure to use the exact wording from the illustration when ordering parts.
For further assistance or inquiries, you can contact Uolfin customer support at +1 850 296 2377 during working hours (Mon-Fri 9:00 a.m. - 16:00 p.m. EST) or email them at uolfin@newdecorworld.com.
Add New Comment