User Manual Q&AAnswer
May 03, 2025 - 03:45 AM
To connect the Velleman VMA341 Digital Light-Intensity Sensor Module to an Arduino board, you will need to make the following connections:
- Connect the GND pin of the VMA341 module to the GND pin of the Arduino board.
- Connect the V pin of the VMA341 module to either the 3.3V or 5V pin of the Arduino board, depending on the voltage you want to use.
- Connect the SDA pin of the VMA341 module to the A4 pin of the Arduino board.
- Connect the SCL pin of the VMA341 module to the A5 pin of the Arduino board.
Make sure to double-check the pin connections and ensure they are properly connected before powering on the Arduino board.
Please note that this answer is based on the information provided in the user manual for the Velleman VMA341 Digital Light-Intensity Sensor Module. For more detailed instructions and information, please refer to the user manual or visit the Velleman website for additional resources.
Add New Comment