User Manual Q&AAnswer
May 03, 2025 - 03:20 AM
To mount the Genmitsu 5.5W Laser Fixed Focus Module Kit on your CNC machine, follow these steps:
1. Disconnect the spindle motor by removing the motor connection from the router main board.
2. Remove the spindle motor from the motor mount.
3. Move the motor mount towards its lowest height using the Jog controls.
4. Slide the Laser Head into the motor mount so that the corners are in the slots of the motor mount and the cooling fan of the Laser Head is pointing upwards.
5. Align the top of the heat sink with the top of the motor mount.
6. Tighten the clamping xxxx on the motor mount, ensuring it is secure but not over-tightened.
7. Plug both connecting cables into the sockets of the Laser Control Module.
8. Mount the Laser Control Module on the rear of the CNC machine on the aluminum profile to the right of the motherboard of the CNC machine using the supplied M3 T-nuts and screws.
9. Ensure that the cables to the Laser Head can move freely so that the laser can move in all axes to the limits of its travel. Mounting the module vertically using just a single xxxx can provide freer cable movement.
Please refer to the user manual for visual illustrations and additional information on mounting the Genmitsu 5.5W Laser Fixed Focus Module Kit on your specific CNC machine.
Add New Comment