User Manual Q&AAnswer
May 03, 2025 - 12:57 AM
To install the BRIZO 106350 Pull Down, Pull Out, and Prep Kitchen Faucets, follow these steps:
1. Slide the gasket and trim ring (if present) onto the tubes with the paper backing oriented up.
2. Remove the paper backing to expose the adhesive and install the gasket.
3. For models with a handle assembly, place the handle onto the valve stem, tighten the set xxxx , and insert the button.
4. Insert the faucet into the sink, ensuring it is centered in the hole.
5. Install the mounting hardware with the supplied wrench until snug.
6. Adjust the final position of the faucet above the sink if necessary.
7. Tighten the hardware until the faucet resists movement, being careful not to overtighten.
8. Place a bucket below the outlet tube.
9. Turn the faucet handle on and open the hot and cold water lines.
10. Flush the lines into the bucket.
11. Shut off the hot and cold water lines.
12. Turn the faucet handle off.
13. Install the hose weight.
14. Push the hose end onto the faucet outlet.
15. Attach the clip as shown.
16. Pull down moderately on the hose to check that it is secure.
17. Turn the faucet handle on and check all connections for leaks.
Please note that these are general installation instructions. For specific details and illustrations, refer to the BRIZO 106350 Pull Down, Pull Out, and Prep Kitchen Faucets Instruction Manual.
Add New Comment