How do I install the FISHER and PAYKEL 60cm Built Under Dishwasher? (FISHER and PAYKEL Built Under dishwasher User Guide)

Answer

manuals.plus

May 02, 2025 - 04:47 AM

To install the FISHER and PAYKEL 60cm Built Under Dishwasher, follow the specific installation guidance provided with the product on delivery and on the Fisher & Paykel website. The dishwasher is designed to fit flush under the kitchen benchtop with a custom kickstrip. It can be installed under bench heights between 820–880mm, fitting flush with cabinetry for a seamless look.

Here are the general steps for installation:

1. Ensure that you have the necessary electrical and plumbing connections. The dishwasher requires a 230V, 50Hz electrical supply with a 10A service and a 3-prong grounding-type receptacle. The plumbing supply should have a 3/4 BSP (20mm) connector water inlet hose with a minimum pressure of 34.5 kPa and a maximum pressure of 1034 kPa. The cold water connection should be at a maximum temperature of 20°C.

2. Prepare the cavity for installation. The minimum overall height should be 820mm, the minimum overall width should be 600mm, and the minimum overall depth should be 580mm. These dimensions may vary depending on the adjustment of the leveling feet.

3. Connect the dishwasher to the electrical and plumbing supplies. Ensure that the hoses and cords are routed to the appropriate sides, as the service outlet at the rear extends to both sides.

4. Adjust the levelling feet to ensure the dishwasher is level and stable.

5. Install the custom toe kick panel according to the provided dimensions. The height of the custom toe kick panel should be between 65mm and 200mm, and the minimum width should be 595mm. The depth of the toe kick recess should be between 52mm and 122mm.

Please note that this answer provides a general overview of the installation process. For detailed and accurate installation instructions, refer to the specific installation guidance provided with the product.