User Manual Q&AAnswer
May 02, 2025 - 04:18 AM
To install the STELPRO SILBH2060 Series Bathroom Forced Air Heater, follow these steps:
1. Cut off power supply at the circuit breaker/fuse before proceeding with the installation.
2. Secure the unit to a wall, 12 inches (305 mm) away from the floor and adjacent walls.
3. Drill three holes slightly smaller than the diameter of the plastic pins provided.
4. Insert the pins into the holes.
5. Insert the two top screws provided, leaving a gap of 5/16 inch (8 mm) between the xxxx head and the wall.
6. Hang the unit on the two installed screws while holding it securely.
7. Secure the unit with the third xxxx at the bottom.
8. Ensure that the airflow generated by the heater remains clear by leaving at least 3 feet (91 cm) in front of the unit and not installing it below an electrical convenience outlet.
Please refer to the installation section in the user guide for more detailed instructions and illustrations.
Note: It is important to have the unit installed by a qualified person and connected by a certified electrician, according to the electrical and building codes effective in your region.
Add New Comment