User Manual Q&AAnswer
Apr 30, 2025 - 10:29 AM
To set up the PLIANT TECHNOLOGIES PMC-900M MicroCom 900MHz Single Channel Belt Pack, follow these steps:
1. Connect a headset to the belt pack.
2. Power on the belt pack by pressing and holding the Power button for three (3) seconds until the screen turns on.
3. Select a Group by pressing and holding the Mode button for 3 seconds until the "GRP" symbol starts blinking on the LCD. Use the Volume +/- buttons to select a group number from 0-51. Press the Mode button to save your selection and proceed to ID setting.
Note: Belt packs must have the same group number to communicate.
4. Select an ID by using the Volume +/- buttons when "ID" starts blinking on the LCD. Choose a unique ID number and press and hold the Mode button to save your selection and exit the menu.
- Pack IDs range from 00-04.
- One pack must always use the "00" ID and serve as the master pack for proper system function. The master pack is designated by "MR" on its LCD.
- Listen-only packs must use the "L" ID. You may duplicate ID "L" on multiple belt packs if setting up listen-only users.
- Shared Talk belt packs must use the "Sh" ID. You may duplicate ID "Sh" on multiple belt packs if setting up shared users. However, the "Sh" ID cannot be used at the same time as the last full-duplex ID ("04").
5. Once the setup is complete, you can use the Talk button to enable or disable talk for the device. A single, short press toggles talk on and off. For full-duplex users, use a single, short press. For Shared Talk users ("Sh"), press and hold while talking to enable it for the device. Only one Shared Talk user can talk at a time.
6. Use the Volume +/- buttons to control the volume. The LCD will display "VOL" and a numerical value from 00-09 when the volume is adjusted.
For more detailed information on menu settings, device specifications, and product warranty, refer to the full available on the Pliant Technologies website.
Add New Comment