How do I install the Maxxima Slim Round Recessed LED Downlight? (Maxxima Slim Round Recessed LED DOWNLIGHT Instruction Manual)

Answer

manuals.plus

Apr 29, 2025 - 01:47 PM

To install the Maxxima MRL-S61245 6 Inch Slim Round Recessed LED Downlight, please follow the steps outlined in the instruction manual:

1. Turn off the power before installation and remove the existing fixture, if applicable.

2. Determine the location and necessary hole cutout diameter using the provided table. Cut the ceiling hole with the listed approximate diameter.

3. Open the DRIVER/JUNCTION BOX cover and remove the appropriate knockout(s) on the side panel. Install the appropriate cable clamp(s) (not included) and insert the electrical supply cable through the cable clamp. Connect the ground wire to the green wire terminal, hot wire to the black wire terminal, and neutral wire to the white wire terminal using the wire nuts provided.

4. Place all wiring and connections back into the box and close the cover. Connect the DRIVER/JUNCTION BOX to the light panel using the CONNECTOR.

5. Use the CCT selector switch on the outside of the DRIVER/JUNCTION BOX to select the desired CCT color of the light.

6. Insert the DRIVER/JUNCTION BOX through the mounting hole and secure it using the mounting tabs.

7. Push the SPRING-LOADED CLIPS into the mounting hole upwards and insert the LIGHT PANEL into it. Release the clips, and the fixture will be pulled flush to the ceiling.

Please note that these instructions are a summary, and it is important to refer to the complete instruction manual for detailed information and illustrations. Additionally, if you are not qualified or unsure about the installation process, it is recommended to contact a qualified electrician for assistance.