User Manual Q&AAnswer
Apr 29, 2025 - 12:05 PM
To install the ALTA Roller Skyline Shades, follow these steps:
1. Ensure that the mounting surface is level. The brackets must be in line and level for the shade to operate properly. If needed, shim the brackets to achieve a level surface.
2. Pre-drill the pocket profile by marking the xxxx hole locations with a pencil. Use a center punch on the marked locations and pre-drill the mounting xxxx holes using a 1/8" drill bit.
3. Insert the bracket into the pocket by tapping it gently into place with a mallet until it is flush with the end of the pocket. Secure the end plates into the pocket using the provided screws.
4. If you are installing a ceiling mount, mount the pocket to the ceiling using the appropriate mounting screws, aligning them with the pre-drilled holes. Make sure to secure the bracket to the pocket/ceiling with the supplied mounting screws.
5. Install the shade by first placing the spring-loaded pin end into the round hole of the bracket. Then, insert the hooks on the clutch or motor head straight into the two slots in the bracket. Once the hooks are through the slots, gently pull downward on the side with the hooks until they lock securely to the bracket. Ensure that the bottom of the clutch or the reset button on the motor points straight down.
6. If you have an AgileLift shade, do not pull the lock pin until the shade is securely assembled onto the brackets. Follow the steps to install the shade first and then remove the lock pin prior to operation by pulling it down.
7. To adjust the position of the installation brackets or remove the shade, raise the shade and insert the lock pin prior to disengaging the shade from the installation brackets.
8. To install the bottom closure, insert it into a pocket on an angle and hook it onto the front side of the pocket. Align it carefully and allow the front of the bottom closure to drop in place.
9. To remove the bottom closure, raise the front of it until the hook disengages from the pocket. Rotate the bottom closure and slowly remove it from the shade.
10. If you need to remove the shade, follow the steps to remove the bottom closure first. Then, lift the control unit (hooks end) to disengage it until the hooks touch the top part of the bracket slot. Pull the shade towards the spring-loaded pin end until the hooks are completely out of the bracket slots. Finally, remove the spring-loaded pin end from the Idler bracket. For AgileLift shades, raise the shade and insert the lock pin prior to disengaging the shade from the installation brackets.
11. It is important to note that for child safety, cords longer than 22 cm or loops exceeding 44 cm should not be accessible to young children. If such a cord or loop becomes accessible, immediately remove the product to prevent strangulation hazards.
Add New Comment