User Manual Q&AAnswer
Apr 29, 2025 - 11:03 AM
To set up and secure the ROTHENBERGER RODIACUT 400 PRO Drill Stand, follow these steps:
1. Positioning:
- Measure the borehole and mark the center.
- Adjust and fasten the base plate securely.
- Make sure the ring bolts do not overlap the lower edge of the base plate.
- Tighten the four-ring bolts to achieve the final fine alignment or adjustment of the drill rig.
2. Fastening possibilities:
- If you are fastening on concrete or brickwork, measure and drill a mounting hole for the dowel fastening.
- Clean the drill dust from the borehole.
- Apply the concrete dowel or brickwork dowel.
- Attach the drill rig and fasten using the U-washer and nut.
3. Bracing with the quick clamp column:
- Align the drill rig and attach the quick clamp column to the base plate.
- Extend the quick clamp column and clamp the drill rig.
- Place a piece of wood or similar between the end of the column and the ceiling to distribute the contact pressure over a larger area.
4. Optional: Bracing with the strut head:
- Place a suitable spacer between the strut head and the wall/ceiling.
- Unscrew the strut head and clamp the drill rig.
- Place a piece of wood or similar between the end of the column and the ceiling to distribute the contact pressure over a larger area.
Please refer to the manual for detailed instructions and illustrations on setting up and securing the ROTHENBERGER RODIACUT 400 PRO Drill Stand.
Add New Comment