User Manual Q&AAnswer
Apr 28, 2025 - 11:16 AM
Installation of the Broil King 17065 Replacement Ignitor Kit is a simple process. Here are the step-by-step instructions:
1. Ensure that the grill is turned off and disconnected from the power source before starting the installation process.
2. Remove the cooking grates and heat plates from the grill to access the burners.
3. Locate the existing ignitor on the grill. It is usually located near the burner and has a wire connected to it.
4. Disconnect the wire from the existing ignitor by gently pulling it off. Take note of how it is connected for reference during installation.
5. Remove the existing ignitor from the grill by unscrewing it or releasing any clips holding it in place.
6. Take the Broil King 17065 Replacement Ignitor Kit out of the box and ensure that all the necessary components are included.
7. Insert the new ignitor into the same location where the old ignitor was removed. Secure it in place by screwing it in or using the provided clips.
8. Connect the wire from the new ignitor to the corresponding connection point on the grill. Ensure that it is securely attached.
9. Reinstall the heat plates and cooking grates back onto the grill.
10. Before using the grill, perform a test by turning on the burners and checking if the new ignitor is functioning properly.
Please refer to the Broil King 17065 Replacement Ignitor Kit Instruction Manual for more detailed installation instructions and diagrams.
Add New Comment