How do I install the IMMERGAS Magnetic Cyclone Filter Kit on my boiler? (IMMERGAS Magnetic Cyclone Filter Kit Instruction Manual)

Answer

manuals.plus

Apr 28, 2025 - 08:46 AM

To install the IMMERGAS 3.024176 Magnetic Cyclone Filter Kit on your boiler, please follow the steps below:

1. Disconnect the boiler from the power supply.

2. Close the xxxx upstream of the filter.

3. Partially discharge the hydraulic circuit pressure as per the appliance instruction manual.

4. Close the second shut-off xxxx .

5. Ensure that the temperature of the system return water is not too hot to avoid burns.

6. Place a container under the filter to collect the water.

7. Remove the clip and pull out the magnetic cartridge by pulling it downwards.

8. Clean the cartridge with a clean cloth and under running water.

9. Put the magnetic cartridge back in place, ensuring that the centring pins match and the sealing O-ring is not damaged. Replace the O-ring if necessary.

10. Lock the magnetic cartridge in place with the clip.

11. Open the two shut-off xxxx .

12. Restore power to the boiler to bring it back to normal operating conditions.

13. Check the operating pressure of the appliance and adjust it if necessary.

Please refer to the provided figures in the instruction manual for a visual representation of the installation process. It is important to comply with the manufacturer's instructions and use authorized professionally qualified staff for installation and maintenance.

Note: The IMMERGAS 3.024176 Magnetic Cyclone Filter Kit is compatible with various boiler models, including VICTRIX HYBRID/PLUS, MAGIS VICTRIX, VICTRIX TT SERIES, VICRIX EXA, VICTRIX TERA/24 PLUS/V2, VICTRIX OMNIA, VICTRIX SUPERIOR, VICTRIX ZEUS SUPERIOR, and VICTRIX ZEUS.