User Manual Q&AAnswer
Apr 28, 2025 - 07:58 AM
To calibrate the meter on the Lindell Audio LiN76 Vintage Limiting Amplifier, follow these steps:
1. Set the meter to GR (gain reduction) mode.
2. Make sure that no ratios are selected by pressing in any ratio button just enough that all four pop out.
3. Locate the meter calibration set xxxx on the back of the unit.
4. Using a flathead screwdriver, rotate the xxxx on the rear panel until the needle rests on 0.
5. The meter is now calibrated.
Please note that proper meter calibration is important for the compressor's functionality. Refer to the manual for visual references and additional information.
Add New Comment