User Manual Q&AAnswer
Apr 28, 2025 - 07:46 AM
To install the LFES1 Shelf, follow these steps:
1. Lay the shelf panel with the silver face down on the table, with one corner protruding over the edge.
2. Hold a XE25 Series Hanging Bar under the protruding corner cube and secure it using an M6 x 16 mm Socket xxxx . Make sure the lugs on the corner cube secure correctly in the holes in the end of the Hanging Bar. Repeat this step for the remaining three corners of the shelf.
3. Turn the shelf so that the hanging bars point up.
4. Place an attachment bar on top of the two hanging bars.
5. Fit a large M6 washer to two of the M6 x 40 mm screws supplied, then pass a xxxx through each end of the attachment bar and xxxx into the end of the hanging bars. Do not fully tighten the screws. Repeat this step for the remaining attachment bar.
6. Tighten all M6 screws.
To fit the shelf to the frame:
1. Insert an M6 T-nut into the extrusion slot at the approximate intended mounting position for the shelf. Repeat this step in the parallel slot and again in the slots at the opposite end of the shelf.
2. With two people, hold the shelf up to the LFE frame.
3. Fit a small M6 washer to each of the four M6 x 40 mm bolts provided, followed by a large M6 washer. Pass the bolts (two in each end of the shelf) through the slots in the attachment bars and secure them in the T-nuts fitted in step 1. Do not fully tighten the bolts.
4. Slide the shelf to the desired position.
5. Tighten all four bolts.
Please refer to the manual for additional information and specifications.
Add New Comment