How do I install the Lightwave LP83 Gang Smart Relay? (Lightwave Gang Smart Relay User Manual)

Answer

manuals.plus

Apr 22, 2025 - 11:05 AM

To install the Lightwave LP83 Gang Smart Relay, please follow the steps below:

1. Prepare a suitable location: The Smart Relay needs to be housed in a suitable enclosure to minimize the risk of contact with live electrical wires. Ensure it meets IEC Class II requirements. If in doubt, consult an electrician.

2. Turn off the electricity supply: Turn off the mains power supply to your existing power circuit at the consumer unit.

3. Connect to mains power: The Smart Relay can be used to switch up to three circuits and always requires mains power to operate. Connect the line and neutral power cables to the Relay as shown in the diagrams. Be aware that existing cables can vary in color and may not always be correctly labeled. If in any doubt, consult a qualified electrician.

4. Linking: To be able to command the Relay, you will need to link it to the Link Plus. Follow the in-app instructions to learn how to link devices. On the Relay, press and hold down any of the three main buttons until the LED flashes blue and red alternately, then release it. The Relay is now in linking mode. Using the App, press the button to link to the device. The indicator on the Relay will flash to confirm that it is now linked.

For more detailed instructions and visual guidance, you can refer to the installation video available on the Lightwave RF website's support section.

Please note that if you have any doubts or concerns about the installation process, it is always recommended to consult a qualified electrician for assistance.