User Manual Q&AAnswer
Apr 22, 2025 - 10:44 AM
To configure the SEALEVEL 7203e Isolated Serial Interface for RS-232, RS-422, or RS-485 mode, you can use the DIP-switches SW1 and SW2 on the card. Here are the steps:
1. Determine the desired mode for each port: RS-232, RS-422, or RS-485.
2. Locate the DIP-switches SW1 and SW2 on the card.
3. Refer to the manual for the specific DIP-switch positions for each mode.
4. Set the DIP-switches SW1 and SW2 according to the desired mode for each port.
5. Once the DIP-switches are set, the card will operate in the selected mode.
Note: The manual provides detailed information on the DIP-switch positions for each mode and their corresponding interface combinations. Make sure to refer to the manual for accurate configuration instructions.
For further assistance or more specific instructions, please refer to the SEALEVEL 7203e Isolated Serial Interface User Manual.
Add New Comment