How do I commission and set up the HYTRONIK Tuya Enabled HF Motion Sensor using the Tuya smart app? (HYTRONIK Tuya Enabled HF Motion Sensor Instruction Manual)

Answer

manuals.plus

Apr 22, 2025 - 09:39 AM

To commission and set up the HYTRONIK SAM12-TY-2 Tuya Enabled HF Motion Sensor, follow these steps:

1. Download and install the Tuya smart app on your smartphone or tablet.

2. Ensure that the motion sensor is properly connected to a 12VDC power source.

3. Open the Tuya smart app and create an account if you don't have one already.

4. Log in to the app and click on the "+" icon to add a new device.

5. Select "Sensor" from the list of device types.

6. Follow the on-screen instructions to put the motion sensor into pairing mode. This usually involves pressing and holding a button on the sensor for a few seconds until the LED indicator starts flashing.

7. Once the motion sensor is in pairing mode, the Tuya smart app will detect it and prompt you to connect to it.

8. Select the motion sensor from the list of available devices and enter the necessary Wi-Fi credentials to connect it to your home network.

9. After the motion sensor is successfully connected, you can customize its settings and configure its behavior through the Tuya smart app.

10. Use the app to set up grouping of luminaires via a mesh network if you have a Tuya gateway and multiple compatible lights.

11. You can also update the motion sensor's firmware over-the-air using the Tuya smart app if necessary.

Please note that the above steps are a general guide, and the exact process may vary slightly depending on the version of the Tuya smart app and any specific instructions provided by HYTRONIK. For more detailed instructions, refer to the instruction manual provided with the HYTRONIK SAM12-TY-2 Tuya Enabled HF Motion Sensor.