How do I install the Bussmann 3723, 3742, and 3743 Add-On Fuseblocks? (Bussmann Add-on Fuseblocks Instruction Manual)

Answer

manuals.plus

Apr 21, 2025 - 09:27 AM


To install the Bussmann 3723, 3742, and 3743 Add-On Fuseblocks, follow these steps:



1. Start by ensuring that the power supply to the circuit is turned off.



2. Determine the desired location for the fuseblock and ensure there is enough space for the block and any additional blocks that may be added in the future.



3. Mount the fuseblock securely using appropriate hardware, such as screws or bolts, ensuring that it is properly grounded if required.



4. Connect the power supply wires to the  xxxx  terminals on the fuseblock. Ensure that the correct wire size is used and that the connections are tight and secure.



5. If using multiple fuseblocks, align the blocks so that the end barriers of each block are adjacent to each other.



6. If using the Bussmann 3742 Add-On Fuseblock, install the end barrier by snapping it onto the end of the fuseblock. This will provide additional safety and protection.



7. If required, use the Bussmann 3723 Marking Strip to label the fuseblock for easy identification. Cut the strip to the desired length and insert it into the designated slot on the fuseblock.



8. Once the installation is complete, double-check all connections and ensure that the fuseblock is securely mounted.



Please note that this answer is based on the information provided in the Bussmann 3723, 3742, and 3743 Add-On Fuseblocks Instruction Manual. For specific installation requirements and guidelines, it is always recommended to refer to the official manual or consult a qualified electrician.