User Manual Q&AAnswer
Apr 19, 2025 - 05:26 AM
To set the flow rate for the Oventrop Multidis SF Stainless Steel Distributor Collector, follow these steps:
1. Carry out the setting while the circulation pump is in operation.
2. Close the valve spindle with a 5 mm hexagonal spanner.
3. Open the valve spindle by turning it anticlockwise according to the calculated preset value. For example, if the presetting is 2.5, turn the valve spindle 2.5 turns.
4. Turn the adjusting xxxx against the valve spindle as far as it will go using a 6 mm hexagonal spanner.
5. If, at a later time, the heating/cooling circuit is shut off by the valve spindle, the last set value can be restored using the adjustment xxxx .
6. Repeat this procedure for all heating and cooling circuits.
Please note that the specific calculations and values for the presetting may vary depending on your specific installation and requirements. It is recommended to consult with a qualified specialist tradesperson or refer to the manufacturer's guidelines for more precise instructions.
Add New Comment