User Manual Q&AAnswer
Apr 19, 2025 - 04:17 AM
To enroll the DSC PG Series Wireless PowerG High Security Mirror Detector into your security system, you can follow the quick enroll or pre-enroll method.
Quick Enroll Method:
1. On a keypad, press [*] [8] [Installer Code] [804] [000].
2. Press and hold the device enroll button (located on the detector) until the LED lights steady, then release the enroll button while the LED is still lit. A confirmation message will appear on the keypad.
3. Press the [*] key to confirm the ID.
4. Enter the 3-digit zone number.
5. Enter the 3-digit zone type.
6. Enter the 1-digit partition number for all desired partitions and press [#]. If using an LCD keypad, you can scroll to the desired partitions and press [*] to toggle the partition.
7. On an LCD keypad, enter the label using the word library.
Pre-Enroll Method:
1. Remotely configure the unique ID number into the system (refer to the HSM2HOST manual for more information).
2. When on-site, press the device enroll button (located on the detector).
Note: If the wireless device has been powered for more than 48 hours without being enrolled, tamper and restore the device to enroll it.
Please refer to the DSC PG Series Wireless PowerG High Security Mirror Detector Installation Guide for more detailed instructions and information.
Add New Comment