User Manual Q&AAnswer
Apr 19, 2025 - 03:19 AM
To connect your effect pedals to the Harley Benton Spaceship Power 50C, follow these steps:
1. Connect the device to a power outlet using the supplied power cord to turn it on.
2. Identify the voltage requirements of your effect pedals. The Spaceship Power 50C provides various voltage outputs to accommodate different pedals.
3. Use the appropriate voltage supply cables to connect your effect pedals to the corresponding outputs on the Spaceship Power 50C.
- For effect pedals requiring 24V at a maximum of 2000mA, connect them to Output 1.
- For devices with high power consumption (e.g., multi-effect devices) requiring 9V at a maximum of 3000mA, connect them to Output 2.
- For effect pedals requiring 9V at a maximum of 250mA, connect them to Outputs 3-4.
- For effect pedals requiring 9V at a maximum of 500mA, connect them to Outputs 5-7.
- For effect pedals requiring 9V, 12V, or 18V at a maximum of 500mA, 375mA, or 250mA respectively, connect them to Outputs 8-9. Set the associated switch above the output to the desired voltage.
4. Ensure that the polarity of the devices you are connecting matches the polarity of the power supply outputs. Using a device with reversed polarity may cause damage.
5. If you have smartphones or tablets, you can connect them to the USB outputs using suitable voltage supply cables.
6. Each operational output (1-9) is indicated by a green LED. If an output is switched off due to overload, the LED will turn off. In such cases, disconnect the affected pedal from the device. After approximately 2 seconds, the normal voltage supply will be restored.
7. To turn off the Spaceship Power 50C, disconnect the power cord from the power outlet.
Please refer to the user guide for more detailed information and safety instructions.
Add New Comment