User Manual Q&AAnswer
Apr 19, 2025 - 03:14 AM
To assemble the Ender 3 V2 3D Printer Meanwell Power, please follow the steps outlined in the user manual:
1. Install the Z-axis limit switch kit and Z-axis profiles:
- Put the end stops sensor on the left side of the Z-axis and use four M5X45 screws to fix it with the base.
- Lock the T-shaped xxxx rod on the Z-axis motor component and use two M4X18 screws to slightly lock the Z-axis motor component on the profile.
2. Install the Z-axis motor kit and T-type xxxx :
- Lock the T-shaped xxxx rod on the Z-axis motor component and use two M4X18 screws to slightly lock the Z-axis motor component on the profile.
3. Install the pneumatic joint, XE-axis kit, and synchronous belt:
- Tighten the tube connector with an open-end wrench.
- Fix the XE-axis kit with two M4X16 screws.
- Put the timing belt through the XE-axis kit with the same direction as shown in the picture.
4. Install the nozzle kit and Z-axis passive block:
- Put the synchronous belt into the profile along the v-wheel of the nozzle kit.
- Lock the Z-axis passive block with one M4X16 xxxx .
5. Install the X-axis tensioner:
- Insert the timing belt into the tensioner block and put it into the X-axis tensioner together with the timing belt.
- Tighten it with a plastic hand xxxx nut.
- Lock the Z-axis passive block with one M4X16 xxxx and then lock the M4X14 xxxx .
6. Install the Z-axis moving kit and adjust the tightness of the X-axis and Y-axis tensioners:
- Manually rotate the X-axis and Y-axis tensioners to the appropriate tightness.
- Make the Z-axis moving kit insert the two ends of the Z-axis profile along the V-wheel on both sides.
7. Install the gantry profile and display kit:
- Install the profile or the gantry frame on the upper part of the gantry frame with four M5X25 hexagon socket head spring combination screws.
- Connect the display cable and fix the screws on the left side of the display module.
8. Install the material rack, gantry cover, and indication xxxx :
- Put the flat round head M5X8 and M5T screws into the material rack.
- Place the spool holder on the rack and fix it on the profile with screws.
- Put the indication xxxx on the motor shaft and place the 2020 profile cover on both sides.
For more detailed instructions and illustrations, please refer to the Ender 3 V2 3D Printer Meanwell Power user manual provided with the product.
Add New Comment