User Manual Q&AAnswer
Apr 19, 2025 - 03:12 AM
To connect effect pedals to the Harley Benton Spaceship Power 80, follow these steps:
1. Connect the device to the mains using the supplied power cord to put the device into operation.
2. Use a suitable voltage supply cable to connect effect pedals or similar devices that require 24 V supply voltage at a maximum of 2000 mA to the output 1.
3. Use a suitable voltage supply cable to connect devices with high power consumption (i.e., multi-effect devices) that require 9 V supply voltage at a maximum of 3000 mA to the output 2.
4. Use suitable voltage supply cables to connect effect pedals or similar devices that require 9 V supply voltage at a maximum of 100 mA to the outputs 3 - 6.
5. Use suitable voltage supply cables to connect effect pedals or similar devices that require 9 V supply voltage at a maximum of 250 mA to the outputs 7 - 10.
6. Use suitable voltage supply cables to connect effect pedals or similar devices that require 9 V supply voltage at a maximum of 500 mA to the outputs 11 - 13. Make sure the polarity of the devices to be connected is the same as the polarity of the power supply outputs. Powering a device with polarity-reversed voltage may damage it.
7. Use suitable voltage supply cables to connect devices such as smartphones or tablets to the USB outputs.
8. Each operational output 1 - 17 is indicated by a green LED. If an output is switched off due to overload, the LED turns off. Disconnect the pedal in question from the device and after approximately 2 seconds, the normal voltage supply will be restored.
Please refer to the user guide for more detailed information and safety instructions.
Add New Comment