User Manual Q&AAnswer
Apr 19, 2025 - 12:59 AM
To attach the lens onto the sensor body, follow these steps:
1. Before installation, apply a generous amount of the supplied O-ring lubricant to the entire length of the lens O-ring. This step is crucial to prevent water from entering the housing and to maintain the warranty.
2. Place the lens assembly flush onto the sensor module.
3. Rotate the lens assembly clockwise approximately five degrees to lock it into place. Refer to Figure 1 in the manual for a visual representation.
Note: The lens can also be installed on the sensor module rotated ninety degrees. Please refer to Figures 3 and 4 in the manual for further guidance.
To remove the lens:
1. Rotate the lens assembly counter clockwise approximately five degrees.
2. Lift off the lens assembly from the sensor module.
By following these instructions, you can properly attach and remove the lens on the WSP-L360-WH Occupancy Sensor.
Add New Comment