User Manual Q&AAnswer
Apr 18, 2025 - 04:55 AM
To connect effect pedals to the Harley Benton 521032 Spaceship PowerBar 60XL, follow these steps:
1. Connect the device to the mains using the supplied power cord to put the device into operation.
2. Use a suitable voltage supply cable to connect effect pedals or similar devices that require 24V supply voltage at a maximum of 2000mA to the output 1.
3. Use a suitable voltage supply cable to connect devices with high power consumption (i.e., multi-effect devices) that require 9V supply voltage at a maximum of 3000mA to the output 2.
4. Use suitable voltage supply cables to connect effect pedals or similar devices that require 9V supply voltage at a maximum of 250mA to the outputs 3 - 6.
5. Use suitable voltage supply cables to connect effect pedals or similar devices that require 9V supply voltage at a maximum of 500mA to the outputs 7 - 9.
6. Use suitable voltage supply cables to connect effect pedals or similar devices that require 9V, 12V, or 18V supply voltage at a maximum of 500mA, 375mA, or 250mA to the outputs 10 - 13. Set the associated switch above the output to the position of the required voltage. The maximum output power of 45W must not be exceeded.
7. Use suitable voltage supply cables to connect devices such as smartphones or tablets to the USB outputs.
Ensure that the polarity of the devices to be connected is the same as the polarity of the power supply outputs. Powering a device with polarity-reversed voltage may damage it.
Each operational output 1 - 13 is indicated by a green LED. If an output is switched off due to overload, the LED turns off. Disconnect the pedal in question from the device, and after approximately 2 seconds, the normal voltage supply will be restored.
Remember to always refer to the user manual for complete instructions and safety guidelines.
Add New Comment