User Manual Q&AAnswer
Apr 17, 2025 - 05:32 AM
To install and configure a Y Soft SAFEQ 6 USB Card Reader, follow these steps:
Connect the USB Card Reader: Plug the Y Soft USB Card Reader into an available USB port on your printer or multifunction device
Install Necessary Drivers: Ensure that the appropriate drivers for the card reader are installed on the device. These drivers are typically provided by Y Soft or may be included with the SAFEQ 6 software package
Verify Device Recognition: After connecting, confirm that the device recognizes the card reader. This can usually be checked through the device's control panel or system settings
Access SAFEQ 6 Administration Interface: Log in to the SAFEQ 6 administrative portal using your administrator credentials
Navigate to Device Management: Within the portal, go to the section where devices are managed. This is typically labeled as "Devices" or "Printers.
Select the Target Device :Choose the printer or multifunction device to which the USB Card Reader is connected
Configure Card Reader Settings: Within the device settings, locate the section for authentication or card reader configuration, you can specify the type of card reader, assign user authentication methods, and set other relevant parameters
Test the Configuration: After saving the settings, test the card reader by swiping a registered card to ensure that authentication works as expected
Ensure Compatibility: Verify that the card reader model is compatible with your device and the SAFEQ 6 version.
Check Firmware Versions: Ensure that both the device and the card reader have up-to-date firmware.
Review Logs: If issues arise, consult the SAFEQ 6 logs for any error messages related to the card reader.
Consult Documentation: Refer to the official Y Soft SAFEQ 6 documentation for detailed guidance on configuration options and troubleshooting.
Add New Comment