User Manual Q&AAnswer
Apr 17, 2025 - 04:52 AM
To install the KURYAKYN 2948 Tracer Chrome Windshield Trim Lights, follow these steps:
1. Read and understand all the instructions before starting the installation. Park the motorcycle on a hard, level surface and turn off the ignition. Let the motorcycle cool.
2. Remove the main fuse.
3. Unfasten and remove the two outer screws securing the windshield. Loosen, but do not remove, the center xxxx . Remove the windshield and set aside. Refer to the motorcycle's service manual for additional assistance.
4. For bikes with passing lamps, remove the two screws that connect the passing lamp's mounting bracket to the upper and lower fork brackets. Disconnect the passing lamp's connector and remove the light fixture. Repeat on the opposite side. For bikes without passing lamps, proceed to step 5.
5. Remove the two screws from each side of the inner fairing and set them aside.
6. While holding the outer fairing in place, remove the center windshield xxxx and tip the outer fairing forward. Unplug the headlight from the connector and carefully remove the outer fairing from the motorcycle. Set the outer fairing on a soft, sturdy surface with the headlight facing up. Set the center windshield xxxx aside for reuse.
7. For bikes with passing lamps, connect the passing lamps' connectors to the newly installed wiring adapters. Loosely reinstall the passing lamps to the upper and lower fork brackets. For bikes without passing lamps, connect the turn signal connectors to the newly installed wiring adapters.
8. Secure all wires in a safe place using the provided cable ties, cable keepers, and/or cable mounts. Ensure that the wires are secured away from any moving parts, pinch points, or extreme heat.
9. Remove the two outer screws holding the trim assembly to the inner fairing. Let the trim assembly gently hang from the secured wires.
10. Align the outer fairing assembly with the front of the motorcycle. Connect the headlight to the headlight wiring harness. Slide the top edge of the outer fairing underneath the trim assembly. Route the wires through the sandwiched fairings.
11. Reinstall the windshield and fully tighten the center xxxx .
12. Realign the trim assembly with the top edge of the outer fairing. Loosely secure them all together using the provided button cap head screws. Make adjustments to the trim assembly, gasket, and wires. Be sure the top edge of the gasket wraps around the top edge of the trim assembly to prevent water from getting behind the assembly.
13. Fully tighten all windshield mount screws and inner fairing upper screws.
14. For bikes with passing lamps, fully tighten all passing lamp mounts. For bikes without passing lamps, proceed to step 15.
15. Reinstall the main fuse and test the trim assembly for proper run/turn operations.
Please note that these instructions are a summary and should be used in conjunction with the complete instruction manual provided with the product.
Add New Comment