User Manual Q&AAnswer
Apr 17, 2025 - 03:45 AM
To install the , follow these steps:
1. Preinstall Check: Remove the strip from the reel and connect the power supply and controller. Briefly turn on the strip using the controller power button to ensure proper operation of the strip, power supply, controller, and remote. After a successful test, disconnect the power supply and disconnect the components.
2. Layout: Lay the strip on the counter below the cabinets. Hold the strips up under the cabinets or measure to determine the lengths of strip segments needed for installation. Cut the strips to the desired lengths, ensuring all cuts are made only on the marked cut lines.
3. Strip Installation: Attach solderless connectors (STN8-2PC) to the strip ends by placing the connector fully over the strip and pushing down the cap until it locks in place. Ensure all installation surfaces are clean and dry. Remove the strip's backing and adhere it to the bottom front edge of the cabinets for optimal illumination. Press firmly to secure the strips to the surface.
4. Route Wire: Route the wire (WP22-2) for strip-to-strip connections under cabinet seams, windows, and other spaces between cabinets. Cut the wire to length and attach the wire ends to solderless connectors by placing the wire fully into the connector and pushing the cap down until it locks in place. Ensure the wires are connected to the correct polarity on the strip.
5. Controller and Power Connection: Use the double-sided foam adhesive pads (3M-FTP) to mount the controller. Connect the lead wires at the end of the strip run to the controller (MCBRF-4A) with wire nuts (WN-2216). Connect the opposite end of the controller to the CPS Connector (CPSF2ST). To bypass the controller, connect the lead wires from the strip directly to the CPS connector.
6. Power Supply Connection: Connect the power supply (CPS-24V-36W) to the CPS connector and apply power to check for proper operation.
Please refer to the included user manual for a general installation diagram and additional details. Ensure that you follow all safety guidelines and consult applicable electrical codes during the installation process.
Add New Comment