User Manual Q&AAnswer
Apr 17, 2025 - 03:12 AM
To install the JENNAIR W11439180C 30 Inch Black Electric Down Cooktop, follow these steps:
1. Gather the required tools and parts listed in the instruction manual, including a tape measure, screwdrivers, drill, level, and socket extension.
2. Ensure that you have the necessary parts supplied with the cooktop, such as the vent grille, pre-filter, plenum, and downdraft motor assembly.
3. Check the location requirements, ensuring that you have the proper clearance and electrical supply. Remove any drawers and install drawer fronts on the cabinet if necessary.
4. Measure and cut the countertop opening according to the dimensions provided in the manual.
5. Connect the UL listed or CSA approved strain relief and conduit connector for the electrical supply.
6. Determine the venting method that suits your installation, whether it's roof venting, wall venting, or venting between floor joists.
7. Install the vent system, ensuring proper clearance and using the recommended venting materials and clamps.
8. Prepare the cooktop by removing it from the packaging foam and attaching the plenum and downdraft motor assembly.
9. Install the foam strip adhesive-side down around the bottom of the cooktop to keep the underside clean and provide a flat surface.
10. Lift the cooktop with the help of two or more people and place it into the countertop cutout, aligning it parallel to the front edge of the countertop.
11. Secure the cooktop by tightening the screws, ensuring not to tighten directly against the countertop.
12. Install the grease filter and vent grille.
13. Make the electrical connection according to the provided options for 4-wire or 3-wire cable connections.
14. Double-check all parts and tools, dispose of packaging materials, and clean the cooktop before use.
15. Reconnect the power and test the cooktop.
For more detailed instructions and illustrations, refer to the JENNAIR W11439180C 30 Inch Black Electric Down Cooktop Instruction Manual.
Add New Comment