User Manual Q&AAnswer
Apr 16, 2025 - 01:33 AM
To install the VOLTECK POSE-360 Motion Sensor Lamp Holder, follow these steps:
1. Choose the desired location for installation.
2. Fix the lamp holder in place according to the provided diagram.
3. After installing the sensor, connect it to the lamp.
4. Test the lamp holder by following the instructions below.
Testing Instructions:
- Turn the LUX xxxx clockwise to the maximum position.
- Turn the time xxxx anti-clockwise to the minimum position.
- Turn on the power and allow the sensor to warm up for 30 seconds.
- After the light goes out for the first time, wait for 5-10 seconds and then move within the detection field to activate the load (lamp).
- If the load does not work, try covering the detection window with an opaque object (such as a towel) and test again.
- The load should stop working within 5-15 seconds when there are no induction signals.
Please note that when testing in daylight, the LUX xxxx should be turned to the maximum position ( ) to ensure proper functioning of the sensor lamp.
For further technical details and specifications, refer to the manual provided with the product.
Important: Before starting the installation, make sure to interrupt the power supply using the circuit breaker or fuse. Ensure that the area is free of moisture and not near heat or cold sources that may affect the sensor's operation. This product is not intended for controlling motor-operated or non-lighting appliances.
For warranty claims or to purchase parts and components, contact the authorized service center or the place of purchase. The warranty is valid for one year.
If you have any further questions or concerns, you can contact the manufacturer's customer service at 800-690-6990.
Add New Comment