User Manual Q&AAnswer
Apr 16, 2025 - 01:25 AM
To install the ENFORCER 4 in 1 Multi Purpose Siren, Strobe, please follow the steps below:
1. Determine the desired location and installation - surface or to a back box.
2. Remove the two screws from the two tabs that attach the mounting base to the main unit.
3. Squeeze the included base removal tool and insert it through the wiring access hole in the back of the unit. Release and pull carefully until the base is removed from the unit.
4. Turn the mounting base over to view the wiring terminals.
5. Thread the wires (up to 8, depending on installation) through the center hole in the base.
6. Using the provided mounting screws, thread the screws through the provided gaskets and then through the four mounting holes in the base to the wall/back box. Ensure the engraved arrow on the base is pointing upward.
7. Connect the wires to the terminals on the mounting base as shown in the manual. Note that audio input requires power to the PWR (+) terminal.
8. Upload a custom message if desired. You can record a message using any audio recording app that supports the MP3 or WAV format. The device's USB input port can be used to connect a computer and copy the file to the device.
9. Carefully slide the main unit onto the base, ensuring the correct orientation and that the terminal plugs are correctly engaged.
10. Test and remove to adjust broadcast volume as needed.
11. Secure the main unit to the base using the two screws removed in step 2.
Please refer to the manual for more detailed instructions and illustrations.
Add New Comment