User Manual Q&AAnswer
Apr 16, 2025 - 01:09 AM
To connect the Sinope TH1300ZB-C4 3600W Smart Floor Heating Thermostat to your heating system, follow these steps:
1. Before starting the installation, ensure that the breakers for your heating system are turned off at the main electrical panel.
2. Unlock and lift the thermostat cover.
3. Connect the heating floor by using the wire connectors load/line located on the back of the thermostat. Make sure to firmly tighten the wire connectors for a secure connection.
4. Connect the ground wire to the xxxx in the electrical box intended for this purpose.
5. Connect the sensor (only for control applications in F mode or with floor limit).
6. Use screws to secure the thermostat to the electrical box.
7. Replace the cover and lock it. Power up the thermostat.
8. After performing a test sequence, the thermostat should display the floor temperature. If not, refer to the troubleshooting guide in the manual.
Please note that the installation of this thermostat should be done by a certified electrician and in conformity with the national and local electrical codes.
Add New Comment