How do I install the Superior Life LHB88UR250DLPS LED Linear High Bay Luminaire? (Superior Life LED Linear High Bay Luminaire Instruction Manual)

Answer

manuals.plus

Apr 16, 2025 - 12:48 AM

To install the Superior Life LHB88UR250DLPS LED Linear High Bay Luminaire, please follow the steps below:

1. Remove the luminaire from its packaging and inspect for any damages. Handle the luminaire with care.

2. For standard chain mount installation, install the chain into the provided wire hanger. Secure the other end of the chain to a structure using hardware rated for the load. Install the wire hanger on the side of the top LED channel. Ensure that the wiring hangers are fully engaged into the side holes on the top channel.

3. Connect the LED high bay wiring to the line voltage wire. Connect the black wire to the hot wire, the white wire to the neutral wire, and the green wire to the ground wire. Use only UL-listed wiring.

4. Note that there are purple and pink (or gray) wires inside the driver compartment, which are 0-10V dimming leads. These should only be connected to dimming low-voltage wiring. If you are not connecting the fixture to a 0-10V dimming circuit, make sure to cap off the fixture dimmer leads separately from each other to avoid improper fixture operation and voiding the warranty.

5. Clean any residues or fingerprints from the luminaire and lens.

6. Double-check all hanging hardware before proceeding with the installation.

Please note that these instructions are a summary and it is important to read the full instruction manual provided with the luminaire for complete and accurate installation guidelines. Additionally, it is recommended to consult a qualified licensed electrician for installation to ensure compliance with local electrical codes and safety regulations.