User Manual Q&AAnswer
Apr 16, 2025 - 12:23 AM
To configure the communication method for the Cc-Smart PN0101 Smart H-bridge, you will need to use the DIP switch on the PCB. The driver supports multiple communication methods, including PWM/DIR, PPM, UART, and more. Here are the steps to configure the communication method:
1. Before turning on the power, set the DIP switch to the desired mode. The DIP switch mode configuration is explained in the manual and consists of different positions for each communication method.
2. Power on the driver after setting the DIP switch to the desired mode.
3. The Run LED on the PCB will blink a specific sequence number to confirm which mode is configured. Refer to the manual for the corresponding sequence number for each communication method.
By following these steps and referring to the manual for the specific DIP switch positions, you can easily configure the communication method for the Cc-Smart PN0101 Smart H-bridge.
Add New Comment