User Manual Q&AAnswer
Apr 16, 2025 - 12:20 AM
To assemble the SILVERCREST STVM 30 B2 Desk Fan, please follow these steps:
1. Remove the knurled xxxx from the pole on the motor unit.
2. Place the pole on the base and fasten it with the knurled xxxx .
3. Remove the 4 lock screws from the motor unit.
4. Attach the rear grille to the motor unit, aligning the rear grille handle upwards and to the rear. Tighten it with the 4 lock screws.
5. Place the blade on the motor shaft. Insert the pins on the motor shaft into the groove on the rear of the blade. Tighten the lock cap on the motor shaft.
6. Remove the lock xxxx and lock nut from the front grille.
7. Loosen the grille clips from the front grille.
8. Centre the hanging device of the front grille on the rear grille. Insert and fasten the lock xxxx and lock nut. Close the 4 grille clips over the frame of the rear grille and the front grille.
9. Adjust the tilt angle manually by loosening the xxxx , adjusting the tilt angle, and then tightening the xxxx again.
Please refer to the instruction manual for detailed illustrations and additional information on the assembly process.
Add New Comment