User Manual Q&AAnswer
Apr 15, 2025 - 11:49 PM
To install the RF433 Smart Touch Switch, follow these steps:
1. Make sure the electricity is cut off during the installation process.
2. Install the switch without electricity and turn on the electricity after installation (cover the glass touch panel).
3. Wait for 10 seconds and then touch the switch to test it. If you don't test it within 10 seconds, the switch may not work properly.
4. If you don't have a neutral wire, you need to connect the yellow capacitor components in parallel to the Land N of the lamp holder, connected in the L1 position as shown in the wiring diagram.
Add New Comment