User Manual Q&AAnswer
Apr 15, 2025 - 11:30 PM
To install the Harvia Xenio Combi WiFi Control Unit, follow these steps:
1. Install the power unit: Mount the power unit on a wall outside the sauna room in a dry place with an ambient temperature above 0 ºC. Do not embed the power unit into the wall.
2. Make electrical connections: Refer to the electrical connection diagrams provided in the manual. Ensure that the electrical connections are done by a professional electrician in accordance with current regulations. Use the recommended wire and fuse sizes based on the heater output. If any fuses blow, replace them with new ones of the same value.
3. Install the temperature and humidity sensors: Follow the guidelines provided in the manual for installing the temperature and humidity sensors. Ensure that the temperature sensor is not installed too close to an air vent, as this may affect temperature readings and potentially cause overheating.
4. Reset the overheat protector: If the overheat protector is triggered, press the reset button on the sensor box (WX232) after identifying and resolving the cause of the issue.
Please note that these are general instructions, and it is important to refer to the specific instructions for installation and use provided by the heater manufacturer. If you have any doubts or concerns, it is recommended to consult a professional or contact the manufacturer for further assistance.
Add New Comment