User Manual Q&AAnswer
Apr 15, 2025 - 10:31 PM
To load labels into the DYMO LabelWriter 550 Label Printer, follow these steps:
1. Make sure the power is turned on.
2. Remove the label spool from inside the printer and separate the spool guide from the spindle.
3. Hold the spool spindle in your left hand and place the label roll on the spindle so that the labels feed from underneath and the left edge of the label roll is firmly against the side of the spool.
4. Slide the spool guide onto the right side of the spool and press the guide tightly against the side of the label roll, leaving no gap between the roll and the spool.
5. Insert the label spool into the slot in the base of the printer with the labels extending from underneath the roll.
6. Align the left edge of the label with the left edge of the label exit slot and insert the label into the slot.
7. Press the form feed button to advance the label into position. If the first label on the roll is not a full label, press the label forward feed button to eject the partial label. Regardless of the label width, the left edge of the label must be aligned with the left edge of the label exit slot for the labels to feed properly.
8. Slide the label guide to the left until the guide aligns with the right edge of the label. Make sure that the label guide does not pinch the label.
9. Carefully lower the top cover.
For visual reference, you can refer to the figures and descriptions provided in the DYMO LabelWriter 550 Label Printer User Manual.
Add New Comment