How do I switch between dry vacuuming and wet vacuuming with the Salente Combo 4-in-1 Vacuum Cleaner? (Salente Combo Vacuum Cleaner Instruction Manual)

Answer

manuals.plus

Apr 15, 2025 - 10:19 PM


To switch between dry vacuuming and wet vacuuming with the Salente Combo 4-in-1 Vacuum Cleaner, follow these steps:

1. For dry vacuuming:
- Make sure the equipment is disconnected from the power supply.
- Attach the paper bag opening to the suction throat of the vacuum cleaner, starting from the bottom and pushing it completely into the bag.
- If you prefer to use the fabric filtration bag or the HEPA filter, attach them to the filtration basket, ensuring there are no gaps for dust to enter the motor.
- Re-install the upper part of the vacuum cleaner back to the tank and secure it with the clips.
- Insert the larger end of the plastic hose into the front inlet of the tank and secure it.
- Connect the desired attachment to the free end of the hose.
- Plug in the vacuum cleaner and turn the switch to Position I for vacuuming.
- After finishing vacuuming, turn the switch to Position "OFF" and disconnect the plug from the socket.

2. For wet vacuuming:
- Make sure the equipment is disconnected from the power supply.
- Remove the paper bag, fabric bag, or HEPA filter if applicable.
- Mount the foam filter on the filtration basket carefully.
- Re-install the upper part of the vacuum cleaner back to the tank and secure it with the clips.
- Attach the desired accessories or tubes to the vacuum hose.
- Plug in the vacuum cleaner and turn the switch to Position I for vacuuming.
- After use, empty the tank and dry it.
- After finishing vacuuming, turn the switch to Position "OFF" and disconnect the plug from the socket.

Note: Do not vacuum solvents, explosives, flammable or hazardous liquids. Always use the appropriate filters for dry or wet vacuuming to avoid voiding the warranty.