User Manual Q&AAnswer
Apr 15, 2025 - 10:11 PM
Installation of the DEEPCOOL RF120 3 In 1 Triple PWM Fan is relatively straightforward. Here is a step-by-step guide:
1. Prepare your computer case: Ensure that your computer is powered off and unplugged. Open the side panel of your computer case to access the internal components.
2. Locate the fan mounting points: Identify the available fan mounting points in your computer case. These are typically located on the front, rear, or top of the case.
3. Choose the desired mounting location: Decide where you want to install the RF120 fan. Consider factors such as airflow direction and cable management.
4. Connect the fan to the motherboard: Connect the fan's 4-pin PWM connector to a corresponding fan header on your motherboard. Ensure that the connector is aligned correctly and firmly inserted.
5. Secure the fan to the case: Use the included screws or any other appropriate mounting mechanism to secure the fan in place. Align the xxxx holes on the fan with the mounting holes on the case and tighten the screws.
6. Repeat for additional fans: If you have purchased the 3-in-1 package, repeat steps 4 and 5 for the remaining fans.
7. Cable management: Route the fan cables neatly to avoid any interference with other components. Use cable ties or clips to secure the cables in place.
8. Close the computer case: Once all the fans are installed and cables are managed, close the side panel of your computer case.
9. Power on your computer: Plug in and turn on your computer. The fans should start spinning automatically, and you can adjust their speed using your motherboard's fan control settings.
For more detailed instructions and illustrations, please refer to the instruction manual provided with the DEEPCOOL RF120 3 In 1 Triple PWM Fan.
Add New Comment