User Manual Q&AAnswer
Apr 14, 2025 - 08:54 AM
To configure the operating mode of the Satel TSD-1 Smoke and Heat Detector, you need to use the DIP-switches located on the detector. Here are the steps:
1. Refer to Figures 4 and 5 in the manual to locate the DIP-switches.
2. Each DIP-switch corresponds to a specific parameter.
3. Use a small tool (e.g., a screwdriver) to move the DIP-switches to the desired position.
4. The DIP-switch positions are indicated as "OFF" and "ON" in the manual.
5. The parameters that can be configured using the DIP-switches are as follows:
- DIP-switch 1: Relay type (NO or NC)
- DIP-switch 2: Alarm memory (disabled or enabled)
- DIP-switch 3: Heat detection (disabled or enabled)
- DIP-switch 4: Smoke detection (disabled or enabled)
Make sure to refer to the manual for the correct DIP-switch positions for each parameter.
Add New Comment