User Manual Q&AAnswer
Apr 14, 2025 - 08:39 AM
To configure the Modbus hardware on the REZNOR 633be0bf27fe1 Signal Pro Control, follow these steps:
1. Set the RS485 serial half-duplex interface.
2. Set the baud rate to 9600.
3. Set the data bits to 8.
4. Set the parity to Even/No parity, depending on the DIP switch address.
5. Set the stop bits to 1.
6. Set the mode to RTU.
For the DIP switch address, use even parity for addresses 0 to 7, and no parity for addresses 8 to 15.
Please refer to the instruction manual for further details and specific instructions on configuring the Modbus hardware.
Add New Comment