How do I pair another door position sensor (DPS) to the Genie Aladdin Connect Door Control Module (Genie Aladdin Connect Door Position Sensor Instruction Manual)

Answer

manuals.plus

Apr 12, 2025 - 12:31 PM

To pair another door position sensor (DPS) to the Genie 39279R Aladdin Connect Door Control Module (DCM) without using the app, follow these steps:

1. Press and hold down an unlit DOOR button on the DCM until you hear a beep. The light above that DOOR button will start flashing blue, indicating that the button is ready to be paired with a DPS. Make sure the button you choose is not currently associated with another door and is not already backlit with a blue LED.

2. While the LED above the DOOR button is flashing blue, press and hold the button on the new DPS until the blue LED on the DPS starts flashing slowly (about once per second). This indicates that the DPS is ready to be paired with a DOOR button on the DCM.

3. When the DPS successfully connects to the DOOR button on the DCM, the blue LED on the DPS will turn off. This process may take a few seconds or several minutes to complete. Shortly after the blue LED on the DPS shuts off, the blue LED above the chosen DOOR button on the DCM will turn solid. This indicates that the DOOR button on the DCM is now associated and communicating with the DPS.

4. Repeat the above steps to pair up to a total of 3 Door Position Sensors with a single Door Control Module.

Please note that the number of DOOR buttons with the blue LED on the DCM should represent how many DPS (and therefore doors) are connected to the DCM. You can have up to 3 DPS connected to a single DCM.

If you need further assistance, you can contact Genie customer support at 1-866-599-4995 or visit the Aladdin Retrofit Kit FAQ section on their website at https://www.geniecompany.com/aladdin-.... The FAQ section provides detailed problem/solution scenarios and video links to assist you with any issues you may encounter during the installation process.