User Manual Q&AAnswer
Apr 12, 2025 - 08:38 AM
To install and mount the TERMA WGWAS065050 Warp S Towel Rail, please follow the steps below:
1. Start by ensuring that the water and dual fuel version of the towel rail is suitable for your specific installation requirements. Check the product specifications and consult with a professional if needed.
2. Locate a suitable position for the towel rail in your bathroom, keeping in mind that it should be close to the water supply and power source if applicable.
3. Once you have chosen the position, mark the desired height and position of the towel rail on the wall using a pencil or marker.
4. Take the mounting bracket MDP 4x and position it on the wall according to the marked height and position. Ensure that the bracket is level using a spirit level.
5. Mark the xxxx holes on the wall through the holes in the mounting bracket.
6. Drill pilot holes at the marked xxxx hole positions using an appropriate drill bit size for the wall material.
7. Insert wall plugs into the drilled pilot holes, ensuring they are securely fitted.
8. Align the mounting bracket with the wall plugs and xxxx it into place using suitable screws. Make sure the bracket is firmly attached to the wall.
9. Once the mounting bracket is securely installed, you can proceed to attach the TERMA WGWAS065050 Warp S Towel Rail to the bracket. Follow the specific instructions provided in the user manual for your towel rail model.
10. If you are installing the dual fuel version, ensure that the electrical connections are made according to the manufacturer's instructions. This may involve connecting the towel rail to a suitable power source.
11. After installation, check all connections and fittings to ensure they are secure and tight.
Please note that the above steps are a general guide, and it is essential to refer to the specific instructions provided in the TERMA WGWAS065050 Warp S Towel Rail user manual for accurate installation guidance.
Add New Comment