How do I install the AXAGON 4x Internal SATA 6G Port PCI-Express Controller in my computer? (AXAGON 4x Internal Sata 6G Port PCI-Express Controller Instructions)

Answer

manuals.plus

Apr 12, 2025 - 08:27 AM

To install the AXAGON PCES-SA4X4 4x Internal SATA 6G Port PCI-Express Controller, please follow these steps:

1. Before installation, make sure to back up the data on the hard disks that will be connected to the controller.

2. Switch off your computer and unplug the power cable.

3. Open the computer case and locate a free PCI-Express slot.

4. Insert the AXAGON PCES-SA4X4 controller into the free PCI-Express slot.

5. Connect the hard disk or optical drive to the controller using a SATA cable.

6. Connect power to the hard disk or optical drive.

7. Close the computer case, connect the power cable, and turn on the computer.

8. The controller should be detected and installed automatically as the standard AHCI 1.0 controller with a Serial ATA interface.

9. For Windows 7, it is recommended to install the ASmedia driver from the AXAGON website (www.axagon.eu/en/produkty/pces-sa4x4).

10. In the Device Manager, check for successful installation of the controller.

11. In the Disk Manager, initialize the new disk and format it.

For more detailed information, please refer to the product manual available on the AXAGON website under the "PRODUCT SUPPORT" tab.

If you encounter any difficulties or require further assistance, you can reach out to AXAGON's technical support by emailing support@axagon.z. They will be able to provide you with additional guidance and troubleshooting steps.

Remember to dispose of the product responsibly at the end of its service life by taking it to a collection point for electrical equipment recycling. Contact your local authorities or the retailer for information on recycling programs in your country.