How do I set up and configure the Linksys Class A Gigabit Switch-PoE Injector? (Linksys Class A Gigabit Switch PoE Injector User Guide)

Answer

manuals.plus

Apr 12, 2025 - 04:51 AM


To set up and configure the Linksys LNKPG-00730 Class A Gigabit Switch-PoE Injector, please follow these steps:

1. Connect the power cord: Plug the provided power cord into the power adapter and then into a grounded AC outlet.

2. Connect devices: Use Ethernet cables to connect your devices (computers, printers, etc.) to the Gigabit switch's Ethernet ports. If you want to use Power over Ethernet (PoE), connect PoE-enabled devices to the PoE ports on the switch.

3. Connect to the network: Connect one end of an Ethernet cable to the uplink port on the switch and the other end to your network router or modem.

4. Power on the switch: Press the power button on the switch to turn it on. The LED indicators on the switch will light up to indicate power and network activity.

5. Configure the switch: Open a web browser on a connected device and enter the default IP address of the switch (usually 192.168.1.1) into the address bar. Press Enter.

6. Log in to the switch's web-based interface: Enter the default username and password (usually admin for both) to log in to the switch's web-based interface.

7. Configure network settings: In the web-based interface, you can configure various settings such as VLANs, QoS, and port settings. Refer to the user guide for detailed instructions on configuring specific settings.

8. Save and apply changes: After making any configuration changes, remember to save and apply the changes in the web-based interface.

Note: It is recommended to consult the user guide for detailed instructions and additional configuration options specific to your setup. The user guide provides comprehensive information on the setup, configuration, and troubleshooting of the Linksys LNKPG-00730 Class A Gigabit Switch-PoE Injector.