How do I adjust the seat width and depth on the AMYLIOR Mid-Wheel Drive Power Wheelchair? (AMYLIOR Mid-Wheel Drive Power Wheelchair Instruction Manual)

Answer

manuals.plus

Apr 12, 2025 - 04:25 AM

To adjust the seat width on the AMYLIOR PD-A20605 Power Wheelchair, follow these steps:

1. Unscrew and remove the 6 to 8 screws located on top of the seat pan using a 3/16" Allen key.
2. Adjust the seat width to the desired width.
3. Put the screws back in place to secure the seat width adjustment.

Note: The width adjustment must also be made on the rear cross tubes that hold the back canes and seat laterally. Use a 3/16’’ Allen key with a 7/16’’ wrench to remove the 2 bolts.

To adjust the seat depth on the AMYLIOR PD-A20605 Power Wheelchair, follow these steps:

1. Loosen the three bolts (A) on the backrest pivot plate on each side of the seat using a ½" wrench.
2. Remove the bolts linking the back to the seat pan.
3. Reposition the seat to the desired position.
4. Retighten the bolts on each side of the backrest pivot plate and tighten the bolts that link the back to the seat pan.

Note: At all times, the screws holding the seat plates and back cross tube must be screwed in tightly and securely to avoid severe injury and/or damage to the seating system.

For further assistance or if adjusting the seat depth affects the center of gravity, please contact Amylior Technical Support for step-by-step instructions. You can reach them at:

Phone: 1 450 424-0288
Fax: 1 450 424-7211
Email: info@amylior.com
Website: amylior.com

Remember, it is important to ensure that the center of gravity and overall stability of the power wheelchair are maintained and optimal in all combinations of tilt, recline, and elevate.