User Manual Q&AAnswer
Apr 12, 2025 - 03:31 AM
To adjust the fastening torque on the Ronix 8018 Cordless Driver Drill, follow these steps:
1. Ensure that the tool is switched off and the battery cartridge is removed before making any adjustments.
2. Locate the adjusting ring on the tool body. This ring is used to adjust the fastening torque.
3. Turn the adjusting ring so that its graduations are aligned with the pointer on the tool body. The fastening torque can be adjusted in 18 steps.
4. The fastening torque is minimum when the number 1 is aligned with the pointer and maximum when the marking is aligned with the pointer.
5. Before actual operation, it is recommended to drive a trial xxxx into your material or a piece of duplicate material to determine which torque level is required for a particular application.
Please refer to the Ronix 8018 Cordless Driver Drill Instruction Manual for more detailed instructions and safety precautions.
Add New Comment