How do I wire the RockFLEET Rock7 device to a power source and switches? (ROckFLEET Rock7 Wiring Configuration Owner's Manual)

Answer

manuals.plus

Apr 12, 2025 - 03:29 AM

To wire the RockFLEET Rock7 device, you will need to connect it to a power source and up to three switches. Here is a step-by-step guide:

1. Power Wiring:
- For the new version (RockFLEET GSM), use the following wire colors:
- Red wire: Power (12/24V DC)
- Black wire: Ground/Earth (Neutral)
- For the previous version, use the following wire colors:
- Brown wire: Power (9 to 32 volts)
- White wire: Ground/Earth (Neutral)

2. Switch Wiring:
- The RockFLEET can be wired to up to three switches (Switch 0, Switch 1, and Switch 2).
- Use the following wire colors for the switches:
- Yellow wire: Switch 0
- Green wire: Switch 1
- Grey wire: Switch 2

3. Switch Activation:
- The switches are activated by taking them to ground or from ground.
- A switch is activated on a change on the switch wire, either going from Low (ground) to High or High to Low (ground).

4. Power Source Requirements:
- The power sources for the RockFLEET device must have 2A circuit breakers.
- Ensure that no voltage is applied to the switch and sensor inputs as it can result in device failure and void the warranty.

5. Installation Considerations:
- Installation should be performed by a licensed engineer who follows all applicable installation regulations, instructions, and guidelines.
- Power the unit using the provided cable, and connect the positive (brown/red) and negative (white/black) cores to your power supply.
- The unit can run on any voltage between 9v and 32v, drawing a maximum of about 700mA under normal operation.
- It is recommended to fit a 2A fuse if you intend to fuse the circuit.

Please note that this answer is based on the information provided in the ROckFLEET Rock7 Wiring Configuration Owner's Manual. For specific wiring requirements or further assistance, it is recommended to contact TracPlus support.